EMAX 80 Gal. Stationary 175 psi Industrial Air Compressor

At the core of the 7.5hp 2 Stage Emax compressors is the pump. These pumps are quiet in operation and built to last. Solid cast iron crankcase will ensure stable crankshaft alignment and will handle more work load under heavy load conditions. Pump also features a precision balanced solid cast iron crankshaft with Timken-Style stainless steel roller bearings on the front and rear of the crankshaft to ensure smooth and efficient operation with less drag and less energy use. 1750 RPM motors run much cooler than 3450 RPM motors because of the higher torque factor. They also yield low harmonic distortion, provide much higher torque in cold weather starting and require less electricity under start up. This unit has a prewired condor starter and pressure switch built into one. Top quality pressure switches with an adjustable screw which allows you to adjust your pressure higher or lower. 100 percent brass check valves with Teflon Seating. All check valves are all brass with a Teflon seating to reduce tank noise when the compressor is running. Valves are preset and sealed for correct settings. In the event that the compressor would not turn off, the safety valves open keeping compressor from building too high of a pressure level in the tank. Top quality plumbing fittings are used to maintain proper sealing when connected to the tank. High quality 100 percent brass ball valves are used for turning air on and off from the air receiver. Extended tank water drain pipe plumbed out the front of the unit with a 1/4 In. ball valve handle for easy tank draining. Taper lock style 2-groove pulleys (not single groove). Use dual 2-groove, B-Style belts to drive the pump. 5 Year Warranty.